Cone crusher feed Time：2015-09-30 15:18:25

Cone crusher feed affects the efficiency of the equipment, proper feeding is the first step in efficient production equipment. So small series summed up the cone crusher feeding, including feeding equipment requirements and considerations.
Feed requirements
1, into the material inside the device should meet the requirements of the feed cone crusher, non particle size is too large, excellent material into the crushing chamber. Meanwhile, the investment amount of material inside the device should not be too much or too little, it is best to make the material can be uniformly covered with the crushing chamber, the material can not be up to the cone crusher rolling acetabular wall level.
2, cone crusher during operation, the ore must be in the middle of the distributor plate, it does not allow the ore directly into a cone crusher cavity, because it is easy to make equipment overload, making liner wear unevenly. To contribute to the material hopper thoroughly mixed to uniformly distributed along the entire crushing cavity, and should try to make the fines and coarse material segregation kept to a minimum level, to minimize liner wear.
3, the installation of the cone crusher and its various components should be carefully checked and crushers base map spatial dimensions, pre-installation feeding equipment to make careful plans to ensure the maintenance crusher equipment should be easy to disassemble feeding device.
Notes to material
1, before the material into the crushing chamber, the material for the best first pre-screening, screening go to feed fines and viscous material, avoiding water more material into the cause clogging materials, reducing production efficiency of the equipment. It should also install a metal detector in order to detect metal objects and other impurities into the crushing cavity, otherwise it will cause serious damage to the inside of the machine, and even cause equipment was forced to stop.
2, in the feed to the attention of the control feed speed, distance falls from high material almost all through, and directly into the crushing chamber without breaking the bottom, this will lead to the adjustment ring is not normal beating, causing the host frame to adjust severely damaged ring contact surfaces. Therefore, we should control the feeding speed, trapezoidal blanking must be used when more dead material or similar deceleration device.
3, stop, you must first stop the feeder, the ore cone crusher chamber is completely discharged only after making cone crusher parking.